Ancien Forum du Club 604International - www.club604peugeot.fr

Retrouvez nous --> www.forumclub604.fr/forum
Nous sommes le Jeudi 28 Mars 2024 23:17

Heures au format UTC + 1 heure




Poster un nouveau sujet Répondre au sujet  [ 4 messages ] 
Auteur Message
 Sujet du message: Chock Problen
MessagePosté: Mercredi 04 Février 2009 14:02 
Hors ligne
Nouveau
Nouveau

Inscription: Jeudi 13 Décembre 2007 21:36
Messages: 30
Localisation: Israel
Hello from sunny Israel,

I have a problem with the chock. it stack and to turn on the engine
I need to open it manualy (by hand), start and wait the the engine will worm up.

1. Is there parts or a new/used automatic chock that I can buy?
2. Can I convert the Chock (with combination) to manual chock?
3. Where I can get the gaskets for the carbutrators ( as I need to clean
but I will not touch them without new gaskets.
4. Is there a way to get the full carburators and chock as a set?


Thanks

Amir


Haut
 Profil Envoyer un e-mail  
 
 Sujet du message: Re: Choke Problem
MessagePosté: Vendredi 06 Février 2009 21:32 
Hors ligne
Animateur
Animateur
Avatar de l’utilisateur

Inscription: Jeudi 13 Avril 2006 17:53
Messages: 444
Localisation: 85 Vendée
Hello Amir,

On the first stage of the carburator, a choke module (aluminium box) is fixed with 3 screws.
In this box, a small rubber part is mounted, that has hardened over the years (because it is
not resistant to fueldamp). This rubber allows the choke valve to open a little in the first
minute after starting the engine.


Image

Years ago I had the same problem and had to find out what caused the problem. It appeared
that the rubber part in the choke module, had hardened.

To find that rubber, you have to remove 4 screws on the back of the choke module. In this
rubber a piece of steel is mounted, as shown on the foto underneath the choke module, which
you have to remove and fix to the new fresh cut rubber part.

If you cannot obtain/find the rubber, I can help you with this part.

By experience I can tell you, that this treatment of your choke module, is the solution.

Good luck with the job.
Best regards,
Paull


Haut
 Profil  
 
 Sujet du message: Re: Chock Problen
MessagePosté: Samedi 07 Février 2009 15:57 
Hors ligne
Nouveau
Nouveau

Inscription: Jeudi 13 Décembre 2007 21:36
Messages: 30
Localisation: Israel
Dear Paull,

Thanks for the explanation.
I have tried to get the parts but wothout succsess.
I have also look into an old (1979) P 504 carburator
but it is complitly diffrent.

I will appriciate if you can get the parts.
Please inform me the cost including shipping to Israel
and I can send you the payment ASAP.

Thanks again,

Amir


Haut
 Profil Envoyer un e-mail  
 
 Sujet du message: Rubber part for the choke
MessagePosté: Dimanche 08 Février 2009 23:13 
Hors ligne
Animateur
Animateur
Avatar de l’utilisateur

Inscription: Jeudi 13 Avril 2006 17:53
Messages: 444
Localisation: 85 Vendée
Dear Amir,

Every Saturday I come in my 6 :lol: 4 shack and can search for the needed part.
Could you send me your address per private message (PM), so we can communicate details?

Best regards from chilly Holland,
Paull


Haut
 Profil  
 
Afficher les messages précédents:  Trier par  
Poster un nouveau sujet Répondre au sujet  [ 4 messages ] 

Heures au format UTC + 1 heure


Qui est en ligne

Utilisateurs parcourant ce forum: Aucun utilisateur enregistré et 2 invités


Vous ne pouvez pas poster de nouveaux sujets
Vous ne pouvez pas répondre aux sujets
Vous ne pouvez pas éditer vos messages
Vous ne pouvez pas supprimer vos messages

Rechercher:
cron
Licence phpBB © 2000, 2002, 2005, 2007 phpBB Group
Traduction par: phpBB.biz